Honda 16100 Z0T 911 Carburetor Review

The carburetor on my Honda was very dirty. It made a lot more sense to just replace at this price point. Time is money. No adjustments are required.

Never had anywhere near the same size: different spacing between bolt holes; carburetor size is different; Fastening of the governor rod is different; the size of the float chamber is different; .

Image shows carburetor, fuel filter, gaskets and spark plug. Just sent a carburetor. I reordered the product and again only the carburetor was shipped. The engine runs with a new carburettor, but I am disappointed that I never received all the parts.

What can I say, I tried one of the cheap $10 carbs and it was a waste of money. It's good that I ordered it at the same time, because the carbohydrate is cheap. only took about 5 minutes. So far my engine is running like new and to keep it that way I now burn premium ethanol free fuel.

Just like the original. The same Honda brand is not like other copies that work with problems. Installed in minutes and turned on the first time. Replaced the old one that was swamped by a hurricane and was completely rusted inside. After starting I had to drain the oil 3 times to drain the water. With every jolt it started without any problems, without smoke, the smell of petrol or unburned fuel. Also ordered a throttle that should work like new.

I was looking for a carburetor kit but who would want to rebuild a carburetor at this price point? Everything about it was excellent except that the ridge on the fuel intake went out and up instead of out and to the side [that would make sense if you buy that]. So I had to redo the fuel line a bit. First or second time lit. Behaves exactly like the original carburetor. Highly recommended if you have a 200cc engine More details: Chinese copies look like cheap crap in comparison!

Carburetor worked great. I installed it on a Honda GX160 engine that is in my TruCut mower. This is a direct OEM replacement that fits perfectly with no modifications. Throttle adjustment is a little painful. Also, in my case I needed two baseplate gaskets as there is a plastic gasket between the carburetor and the engine cylinder head. After installation, the engine started on the first pull. A great product at a fair price, sold by small businesses that are in many ways the backbone of our US

Came in a Honda box, looks OEM, hard to tell. I called my local dealer who told me $79 for this carburetor. It's hard to believe the price difference when it's truly OEM. Twisted, the compressor turned on for the first time. Good product, easy to install, just two wing nuts, remove air filter, two 10mm nuts (head size) on the side, one screw on top, remove plastic carb cap, then when you slide the carb off the studs, press the Disconnect the fuel line with a needle tip (careful, fuel will…