Enhance Your Cutting Plotter with HQMaster Blade Holder Base for Precise Vinyl Cutting Operations Review

This blade holder is no good. Looks good at first glance, but fits rather loosely in my Roland GX-24 blade holder head. I can't return it because I live abroad so I took some thermal tape and wrapped it around the aluminum area to make it tighter which helped a bit. I would not buy this knife holder again.

Bought two of these and both were junk. The blade did not spin freely in either of them and dragged along the edge of the adjustable sleeve. One had a single o-ring stopper, the other had a double o-ring stopper on an adjustable bushing. None of the holders would cut a trial circle unless it looked like a potato. Both ended up in the trash can.

Terrible quality, item came piece by piece with no fitting instructions. When I finally assembled it properly, the bearings turned out to be complete rubbish and will not allow the blade to rotate smoothly, resulting in poor quality of cut. This part would be perfect if you want Roland to cut like a $200 Chinese junk plotter. Update: The manufacturer contacted me and offered to send me a new mount. The new one has been fitted correctly and the blade turns just as smoothly as the original…

If you have a newer GCC plotter model like icraft 2 or Expert 24 LX that uses 2.5mm and are having trouble getting blades for it then this is the one Replacement holders for you must use these 2mm easy to find blades. First you need to understand how to use the product without leaving negative feedback and I can tell you from my personal experience that this is a quality product. So for GCC users, screw the black cap all the way down and adjust the blade depth from the top. YES it is up, remove