🪥 HQRP 49x17mm Battery-Powered Toothbrush Replacement Review

. This is NOT a direct replacement for the original manufacturer battery. HQRP only correctly determined the length of the battery. This battery has the positive and negative terminals welded at each end on the center, while the original battery has the positive terminal welded on the center and the negative terminal welded off the center. This is because the negative pin hole is off center on the PCB. This causes many problems that this replacement battery ignores. Also, the leads on this…

The battery fits well the only thing I would recommend is the negative tab which needs to be welded to the right of the center battery access. This would make the installation much easier. Overall, though, the setup wasn't that bad. You will need to bend and then trim the flat tumbler at the tongue before inserting it into the PCB. Delivery was very quick and well packaged. Good business supplier. I recommend this battery as a good replacement for the Triumph Professional toothbrush.

prompt delivery; The instructions only say "this requires soldering skills". I found an example on YouTube and was successful the first time. The negative tab of the foil didn't match the circuit board so it flexed a couple of times. The brush works great; good to go!

YOU SHOULD BE ABLE TO UNLOAD THE ENDS OF THE OLD TERMINAL STRIPS AND SOLDER THE ENDS OF THE NEW TERMINAL STRIPS. USE A SEWING NEEDLE AND DENTAL RINSE TO PULL THE BATTERY TERMINAL BAR THROUGH THE HOLES IN THE CIRCUIT BOARD. BEND THE END OF THE BATTERY CONNECTOR STRIPS AROUND THE LOOP IN THE FLOOSE AND USE THE NEEDLE TO PULL IT THROUGH THE HOLE IN THE CIRCUIT BOARD.

This replacement battery has a capacity of 2200 mAh instead of the original 1800 mAh battery, but is slightly longer than the original battery and the protrusions are simple flat pieces of soft Metal, not springy, beautifully shaped metal, you just can't save your Braun Triumph toothbrush with it. more due to the fact that it is a Ni-MH battery at the end of its life. You'll need a few tools, some basic soldering skills, and watch the video titled "Changing the Battery on a Braun Oral-B Triumph

Well suited for orab b replacement batteries of the same size. The tabs are wider, you have to cut them off. My 9000 toothbrush works like new