IBrightstar Flashing Blinking Replacement Brilliant Review

Bought for a 2014 RAM 1500 didn't work for me. The flash kept getting a message on the dash that the turn signal wasn't working so I just returned my factor bulbs to avoid a speeding ticket. After reading the reviews it seems I'm not the only one having this problem.

Love that the light is really bright. It really warns other drivers. The only thing I don't understand is that since I took it to the auto mechanic he had to glue it in place because the fit was a bit loose. Constantly turning on and off like it has a deficit. Since he uses tape, I hope it works properly for a long time.

2018 Tri-Glide. Brilliant! Fits like it was made. Defect. Turn signals and hazard lights flash fairly quickly. While this might sound crazy, I like the different combination of flashing between the top and bottom lights. If the drivers behind me can't see those lights, then Houston, we have a problem.

These lights will flash 3 times then stay on. It is not good if you also signal a right or left turn. Because the turn signal flashes too. The lights flash at different times, which is confusing for other drivers. You can use them in the third breakthrough light, but don't use them for anything else.

With LED load balancer installed they will flash either 1 or 2 times. Then the sequence begins again. They are bright and I think the flash works well and draws the attention of other riders. 3057K bulbs replaced. brake lights and turn signals. Make sure you buy LED load balancers, ie resistors, one per lamp (resistors 12 volts, 30 amps).

They didn't work on my 2011 GMC Sierra. When I first installed them they over glowed so I bought the resistors recommended for them which slowed them down a bit but they were disabled when synced ie they didn't blink together! The brake lights worked great but the turn signals didn't work properly so I just put the factory bulbs in and called it a loss!

Love these lights. Placed on my Messenger GMC and they help. In New York people love to ride on your tail and this light sends them a clear warning that you are going to slow down and stop. I like the brightness and the strobe effect. Easy to install, just check polarity like any LED light. It will blink about 4-5 times before turning solid bright red. I definitely recommend it to everyone.

Added these to a pair of aftermarket taillights on my 2011 Ford Ranger. I connected them in parallel to the existing brake lights. Rear visibility is greatly improved and the triple flash occurs even when the parking lights are on. I am in the restaurant repair and maintenance business and often have to park on the street or in an alleyway. They really stand out and advertise the vehicle as stopped or parked. Today, when drivers are distracted, anything and everything helps.

Mounted on the back of a camper trailer to brighten the light. . 300% brighter! Cars following them continued to back away when the RV's brakes were applied. Rapid flashing when the light is first switched on attracts the attention of following drivers. This greatly reduced the number of cars behind my trailer. Also some installed on the tractor (truck). Immediately noticed an increase in brightness. This reduces the tailgate when driving a truck without a trailer. I plan to add them to my…