Iceberg Thermal IceGALE Performance 3 Pack Review

Made with quality. The bearings are serviceable, I peeled off the sticker and immediately filled in a few drops of oil (I use gear oil 75w-90, it noticeably removes the rustling of bearings). I bought this fan for the Thermalright Le GRAND MACHO RT tower instead of a slow and quiet fan. Of course, it was not possible to achieve a special decrease in temperature (Apparently, it remains only to overcome the fear of dropsy leaks and put it on. By the way, this fan can be used as a desktop fan in…

I took this valve for a jonsbo hx 6250 tower cooler (the regular one began to tap). Precisely because of the fact that you need to blow through the radiator and you needed a good static pressure (at least 2.8 mm), and as it turned out, fans with such characteristics are not cheap. This one fit perfectly! And it got quieter. It works quieter than regular! But! Not in the entire rev range: after 1800 it blows like a soton! And the noise is only from the air flow, no other sounds.

As soon as the speed approaches the maximum, the metal dust mesh filter is dragged into the blades. I bought protective grilles, the problem is solved. Pros below: Huge power, storm spirit, storm and hurricane in the middle, and soft anti-vibration corners around. With its cons: If they do not spin to the fullest, then they live calmly, but after a certain threshold, a crazy howl of the wind begins. Do not put such a computer in the bedroom.

Got pros: Clearly, as described, animals and tears off the linoleum from the floor Cons below: Unfortunately, as described, it in animals and tears off the linoleum from the floor

It looks like I got a marriage, one creaked at maximum speed, the second just buzzes, a terrible hum presses on my ear, even at low speeds, took it to online trade, diagnostics for 20 days, I won’t be surprised if they refuse to exchange for normal ones))

Huge turntables that, due to their noise-producing 2500 rpm, are only fit for miners. I enclosed myself in a small, stuffy building, reduced the maximum speed to 75%, and used two of these 140k for blowing in and one 120k for blowing out (+ dropsy for blowing out). I lowered the temperature by ten degrees in comparison to the old, dead aerocules. In demanding games, the Zotak 3080ti and 5800x operate at 65–72 degrees. Is it even legal? Card with affordable cooling. The card used to warm up to…

Very powerful fan. Replaced the chirping Noctua A14 with Icebergs. The flow of Icebergs at the same speed as Noctua is higher, while the noise is less. There is no "chirring" of motors at minimum speeds. At 1500 they are no longer audible, but the flow is impressive, at 1800 it is still comfortable. Flow 105-110 at 1500 rpm, at 1800 already 125-130. I found it cheaper than in the Amazon by 40 percent - in OnlineTrade. I tried to use the promotion "find it cheaper and make a discount of 500 from

In general, I do not recommend taking. The turntable is very good, but when the PC is started, the default BIOS gives maximum volts for all fans and our patient howls like a helicopter taking off for a couple of seconds. Wake up the whole house at night. You can take something quieter. Its pros: A good blowout. It's almost inaudible at low revs. Rubberized feet, wrapped in waxed paper in a box - looks like a premium product. Cons: When the revs go over 50% and beyond, the howl becomes…

With its pros: The ventilation of the hull has been greatly improved. Changed regular case NZXT. Has cons: Relatively high noise level. After changing the fan mode in the BIOS, I found a happy medium.