🖨️ Stepper Integrated Printers: Iverntech's Efficient Power Transmission Products Review

This motor was purchased as a main component for a work project. It moves an important part back and forth along an axis. This motor was easy to set up using the Arduino Mega 2560 and A4988 driver. Once I connected it to a constant power supply it sounds very clear when it moves. I will buy more of these as the project grows and I need more.

Existing instructions document the use of a longer lead screw and the need to cut it to length. This 210mm length does not need to be trimmed, but the original screws are not long enough so you will need (10x) 10mm M3 screws for the brass. Nut and mounting adapter: //thingiverse com thing:2199805

My device only lasted about 300 seconds overall before it stalled. The load was only 2 ounces and required 6 inches of travel. Worked well the first day of assembly and testing. Then after I came back to use it 3 days later it was completely locked. I replaced another NEMA17 stepper motor and it worked great so my controller and electrics are fine. I tried to manually start the engine after disconnecting it and at first it didn't spin at all. At the end he began to turn, but slowly and with…