🛠️ High-Quality Carburetor Replacement for Yamaha Raptor 660R YFM660 YFM 660R Carb 2001-2005 by JDMSPEED Review

piece 💩 Used floats, float needle and saddle but they are not plug and play, that's for sure! Repaired the OEM carburetors with the parts mentioned, fitted the carburetors and started straight away, so save yourself the hassle and just rebuild the OEM if you can.

"Cheap" carburetors with some modifications and tuning work there. I had to replace the pilot and main jets along with needles and springs. Just buy a dyno kit and some pilots. I also drilled some larger holes in the rails so they close quicker than the standard rails.

My Raptor 660R Carbs was repaired by a certified Yamaha mechanic. The mechanic used parts from these carburetors to rebuild my old carburetors. According to the mechanic, the Yamaha Carb OEM kit was of a much higher quality. So this product is great for renovation but may not be the best buy for a full replacement.

The pilot jet on the left carburetor is larger than stock. This means you cannot change it. So unless you run like a regular pilot, these carbs are not for you. In addition, the guide screws also have different threads. Secondary and standard fuel screws will not fit. But they work fine, just don't expect to be able to embed them other than the mesh and pins.

There is a Yamaha Raptor 660R. The carburetor was only leaking from the bottom, instead of fixing it I thought it would be nice to put a new one in. After installing the new carburetor I had nothing but problems with it. I'll have to take it off and make some adjustments obviously because it's misadjusted or it's a bad carburetor.

These things are amazing for the price. Very good quality for the price of two carbohydrates. That being said, I would never consider putting them on and expecting good results without tuning. Bad reviews I guess because of that. I bought these to replace the stems as they were corroded and all the seals were shot. Get all the nozzles and needles, open and sell them. Didn't even know they were sold out. Of course I had to fiddle with the propeller to get it out of idle but they work amazing!

Bought for my Raptor 660. It looks identical and just assembles. I didn't run it as it came in for a perfect rating, but I made a few mods based on other reviews that seemed to work great. I didn't have any metal shavings inside as some have reported, but I did have a major problem with the choke. Using small pliers with long needles, it took some time to pull the plunger out to connect the choke cable. I installed the dynamometer kit right away so I knew what injectors were in it. I also used…