💾 Protect Your Precious Memories with the JJC MC-MSD16 Rugged Water-Resistant Memory Card Case for 16x microSD Cards Review

Doesn't hold microSD cards as securely as it should. I have a version of the Pelican SD card with microSD slots for SD on half the case and they hold up well.

The small cutouts in the foam that are supposed to hold the micro SD cards don't fit properly. So all the cards rattle in a well-made case. He just doesn't do what he's supposed to do.

It is very difficult to put the SD card in the right place, sometimes it just pops out. If you can get him to stay, good luck, you'll need long nails or a knife. Your choice of inner foam was wide and very poor, it appeared to be a good boot.

I bought this case by mistake thinking I was buying an SD case. No problem, I thought. . . I'll just send it back BUT NO, for absolutely incomprehensible reasons this item is NON-REFUNDABLE A VERY BAD PURCHASE

Holds cards very well. No problem with them falling out while the case is in my backpack or anything like that. It's really easy to tell if the foam is a reliable kart grip. The foam is really hard, but in a good way. Keeps small bugs in place. Recommended coverage by. The only thing it doesn't have is space to write the name of the SD card or anything other than on the foam itself. However, it's okay. Post it is pretty cheap and works the same way.

This card "wallet" doesn't hold cards securely. The slots are not shaped properly, the cards almost fit in but fall out every time you open them. I lost my 64GB card on set and never found it. I lost 35 minutes of footage! Don't buy this!

Neoprene foam is too thick at the inserts. Inserting a card with something you care about is a little stressful. If you slide the card straight or at an angle into the slot, the card will bend. The notch is not deep enough for the rubber to hold well. As a result, one or two will be out of place after some shaking. I'll keep it, otherwise it's well made. Solid latch, durable thick plastic and silicone gasket. My workaround would be to add a foam insert that presses against the cards when the…

I wasn't expecting much for such a low price but this case is made like a tank. It's a bit heavier than I expected and sounds tight. The card slots work but don't really fit my SanDisk cards snugly, but seems good enough considering the case definitely won't open accidentally.