Enhance Car Instrument Cluster with Jtech 10x T3 Neo Wedge LED White Panel - A/C Dash Climate Gauge, Heater Control Light Bulbs Review

Chipboard with great appearance, seems to be of relatively good quality, no defects found yet. A purchase for those looking to upgrade their small electronics in their vehicles to LED lights.

Turn around and find a reliable lamp manufacturer. This is the worst art. Above the side lamps that do not allow them to be fixed down in the nests of the body. I ordered a pack of 10 and received 4 working and 6 broken. Not to mention it's the cheapest plastic base out there. I do not recommend.

I bought 2 packs of these bulbs to renew any burnt gauge bulbs on my Honda Ridgeline. It's a bit tedious and you have to twist them if you insert them with wrong polarity (unknown). They light up well and look almost standard. Out of the first 10, 2 didn't work at all. So I order 2 sets. And I have spare parts.

First of all yes it's the right size I need and no I didn't order the wrong ones! Now they look like they were collected by kids in science class. The wires are the wrong size (too big) making trying to attach them almost impossible. I say almost only because I managed to get 1 to work, but to be honest I was uncomfortable leaving it to cause a short!

This is garbage. LEDs are bright when you can match them. They don't have a proper slot to insert a screwdriver. The plastic is so soft that it's almost impossible to get them to stick, even if you manage to screw them on. I had to replace 8 bulbs and after purchasing a pack of 10 I was able to replace TWO bulbs. The base plastic is too soft and cheap. I should buy something better and take it out.

tested all 10 and all caught fire. Difficult to fit a heated seat switch in my Mazda due to poor quality plastic base. The twist-and-lock flat slot is flat and soft, allowing the plastic slot to pop out before the bulb rests on the locking tabs. Maybe the locking lugs are badly formed? I was able to get them to lock by inserting locking ring pliers into the two holes in the base and twisting them. That's how they work, just PIA. What do you expect for less than 70 cents each? Haven't used it…

So I bought these for my 2005 acura TL internal AC, AC, sunroof and all the little lightbulbs that are in the car. So the facilities weren't the best. It took me a while to get them spinning. But once you get it. It's pretty cute. I want them to be with 2 LEDs on them. Because there are certain places where the lightbulb shines from the side. Therefore, the light on for some of the buttons is not that bright. But it definitely adds a really great feel to your car's interior. That makes night…

These little guys use very little power, last forever and are incredibly bright. The brightness is great for temporary illumination, but I found the LEDs for the 'go' - Gauge in the center of my instrument cluster that's on all the time when I'm driving was actually annoyingly bright. The dimmer of the instrument cluster does not work with LEDs and therefore cannot be switched off. I ended up replacing one of the old bulbs (only a couple of my original ones had burned out) back to the "traffic…