🏍️ Kinstecks Motorcycle Indicators - Flowing Turn Signal Lights, Motorbike 12V LED Bulbs for Motorcycle, Scooter, Quad, Cruiser, Off Road (4PCS) Review

For the price they worked great. Just don't expect top quality. I also had to put the stem back on light after installation.

Great headlights. So far they are working very well. On my bike, the cables are not red, they are black. On the right is a green-blue wire, on the left is a green-yellow-brown wire. Green is a minus on both sides, hope that helps.

I installed them on my Dr650. The light part seems to be glued to the part that attaches to the bike. I put the bike on the trailer and when I got there the nut and bolt were still there but there was no light. Went for a ride and by the time I was done someone else had. The bike has not been tipped over

They were sent unpackaged in a small box. As a result, the lenses were worn. While I'm sure round connectors are useful for most bikes, I have connectors. I had to drill out my tail to fit the 1/2 threaded post. A big plus, with a row LED setup I don't need a resistor.

There are only two wires, it is difficult to mess up during installation. One thing I would like to give this product is the price - they are very cheap for a set of four. The problem I'm having and the reason I got 2 stars is that the arrow doesn't light up at the end. set I installed. So they are not as bright as I had hoped. I have to keep my fingers crossed I won't be behind.

I was looking for cheap, elegant turn signals. Bought these hoping for the best. I had to send them back. Half of the LEDs didn't work. The LEDs that worked were very dim. I've seen the same complaints about any cheap pair of turn signals. However, another pair I bought from Amazon worked great after returning them! (Motorcycle Acelane Led Blinker Blinker) Medium. Not skinny.

Worked very well for a few months but here we have less than 30 days to go before the return deadline and they have started misbehaving, blinking incorrectly and being nervous. Even when they worked well, other drivers said they had a hard time seeing them in daylight - maybe because of the tinted lenses? You'll need resistors for installation, as with any incandescent to LED conversion, but that's fine.