🔧 KIPA Carburetor Rebuild Repair Kit With Float - Compatible Replacement for 1970-1973 CB350 CL350 Twins, Carburetor # 3D, 722A, 726A & 728A - Engine Number 1065279 Review

nozzles are not drilled directly not usable. The floats were fine, the needle valve and seat were stuck, fuel was not flowing.

Save yourself the trouble if you own an old Honda, go to common-motor.com and buy decent stuff. They also have a variety of videos available.

I received my package a day earlier than expected but a float and both plunger needles are not good. The float was bent and I was able to get it to work, but the plunger needles are junk.

The kit had everything I needed. 2 total. There were floats, emulsifier tubes. Multiple jet sizes with fresh o-rings, needle jets, house shaped seals and bowl drain plugs.

Nozzles are NOT marked with size. The biggest complaint is that this seller rips off the 4in1 photo! Look closely you will see a 4into1 stamp to the right of the picture on one of the emulsion tubes. This kit is NOT the same quality as the 4into1s kit, this is made in China, 4into1 is Taiwan and the injectors are marked. I bought this kit but only used the rubber parts from it, not run the carburetors yet. The floats appear normal, but the jets are a guessing game trying to figure out the size,

As the title suggests. Most of the components fit like they came from the factory, but the main jets didn't go in without a fight (the o-ring seemed to be cut too small and therefore the o-ring OD was too large to fit the correct hole). Also, there are absolutely no size markings on the injectors, so you really need to compare the ones you take out with the ones you put back in to make sure you're putting the right size injectors in the carburetor. TL :DR - Not a bad set for the price, but…