🔧 KSP Tubular Black Upper Control Arm Suspension Kit for 2004-2020 F150, Alignment Lift 0-2", V2.0 Review

It says you can fit 35" tires on factory rims. I run them to 34.5 and they rub on the rock. They squeak like crazy too. Enter bit more and get better quality I have to collect them and they have cheap brass Zurka grease, I threw them in the trash, I don't use them.

Unfortunately they didn't fit my 2012 F150 5.0 XL. The Amazon website says it will, but it doesn't. I had to send it back to the seller and got my money back. They will not fit the OEM spindle above where the screw is located. The hole in the spindle was a bit small.

The controls themselves are not bad and easily fit my 2020 f150. But the smears are complete nonsense. 3/4 of these broke while filling and one broke in my oiler and now I have to replace the end. So I'm only driving with two and a half points. FIXED GREASE POINTS!

I really like the look of these levers, but the ball joint is damaged. I had to disassemble the driver's side to install the spacer after installing these levers and the threads on the ball joint were stripped. I would rate these hands higher if I could contact the company and resolve this issue.

I have been happy with the product so far but I have to say someone messed up the packaging with the control lever. The ball joint nut was the wrong thread pitch so it stripped the ball joint stud and I didn't notice until I made about 3 turns on it. Trying to find a die with an M14x1.50 thread was a big problem, but I found it.

These levers are well made and good looking. Time will tell how long the ball joint will last. I have a 1-1/2" alignment kit on my 05 F-150 and the ball joint angle on the KSP Performance upper arms is much closer to the original unraised truck geometry with the standard upper arms. The price is excellent value compared to several other companies offering modified control arms.

The levers themselves are quality metal and provide the correct angle for a level truck, but the grease fittings are cheap brass and will break either when pushed into the levers or when attempting to add grease . They could have just supplied good quality rubber bushings, but those polymer bushings are noisy as hell and need constant lubrication. Now I have to either take it to the shop and replace the grease fittings with proper ones and refill them regularly, or just replace the levers with…

3/3/2020 Made a 2.5" alignment kit and these arms rub on the strut spring only on the passenger side at full rotation. Tried to contact ksp with no success. Fettzerts are terrible too, don't even try to use them if you're still planning on making these hands after I told you to buy other more expensive ones. They're also quite noisy, even when well lubricated. I'm not happy with them. I'll pick an icon or something better when they break. I haven't even finished welding school yet, but I'm…

Overall the arms are made from quality tubular steel and the construction feels solid. The upper ball joints are sealed and cannot be replaced without a press. A well sealed case should make this unnecessary. Lubrication ports are available wherever you want them. Be careful with mirrors. I have over 8 years of automotive experience including deep, technically complex repair processes. I replaced the driver's side control lever and the fit was satisfactory. However, the upper ball joint nut…