Quality Labwork Intake Manifold Boot Joint Carburetor for Yamaha Warrior YFM350 1987-2004 – Perfect Fit! Review

Arrived a day early, same size as the defective part it replaces. The quality is still unknown, I will try not to forget about the update.

To be honest for the money what I expected. The dimensions are slightly different from the factory specs for my Yamaha Warrior 350. The washers supplied with the boot are too large in diameter to be used and the carburetor nuts are too large to be bolted on without cutting the rubber on the boot.

Seems to fit. But not. Bolts cannot be screwed in. The nuts are too big to tighten once in place. Even tried old screws and parts, got pissed off after 30 minutes and came back. Parcilla has a regular part. Stupid people shouldn't sell parts they don't know about.

Please do not buy! After less than a month of use, the quadricycle stopped working. Took a "quick" approach and narrowed it to air. After removing all the plastic, I found that the trunk was nearly snapped in half. Raised the carburettor to close the torn gap in the trunk and was able to start with no problems. PLEASE do not buy! Buy an original Yamaha case or an aluminum case. save your money The guarantee is only valid for 30 days!

This is the second one I've bought. The first developed a hole in the center rubber section after three or four months of use on the 350 Warrior it was mounted on. The engine mounts are good, the airbox is tight. I hope it was only broken because it was working fine when it did. Cheap enough so not a big deal but if the original lasts 10+ years. I hope this lasts longer and isn't a problem.