🔌 LANMU Micro SD to SD Card Extension Cable Adapter: Compatible with Ender 3 Pro, Ender 3, Ender 3 V2, Ender 5, Monoprice Mini 3D Printer, Anet A8 3D Printer, Raspberry Pi, GPS – 5.9in/15cm Flexible Extender Review

I have bought three of these devices so far and they are all reading, writing and transferring data fine. I prefer the shorter cable as I use it with my 3D printer to convert from MicroSD to SD card. The SD card slot has a fully functional spring mechanism. The only downside to these cables is that they can be easily pulled out of the microSD slot. You must also be careful not to pinch, scratch, or kink the ribbon cable as it is very thin and not well protected.

was trying to connect an extension cable to my raspberry pi 4 and because of that I had constant crashes where sometimes the raspberry pi recognized it and it was about 50% cheaper was . time

I don't know what the problem is, but the connection to the car is clumsy. Might be a printer, but my microSD cards aren't hanging around. The cable is very loose and doesn't lock properly. Had the same issues when swapping (what about "clarity, thickness, warmth in this review?"). They have nothing to do with the product.

I was so happy to hook this up to my Ender 3 Pro 3D printer to reinstall the SD card slot. I had no idea this could cause a short on the motherboard. The original motherboard stopped working. I thought it was a board. I bought a new board that has been printed for a long time. The second attempt to use the second motherboard failed!

Poor connection to the printer's card reader, it's loose. I can read the contents of the SD card when I plug an extender into the printer, but if I remove the SD card and plug in another, it still shows the contents of the first card. I have to unplug and plug the power strip back in. There was a sticker on the box saying it was tested so I'm assuming it was sent back. This is my second card extender from two different companies. The first one didn't work at all unless I wiggled it in the…

I have a car dvr that attaches to my rear view mirror and the tf card goes in the top of the unit and I always had to pull the rear view mirror down to put the card in and out. This device allows me to remove and replace the card as needed without changing the position of the rear view mirror. In fact, I was a bit surprised that it would work since it was primarily designed to be used with 3D printers. I have a 3D printer and it works. The price is very affordable and this item is a great way…

I just bought it, packaged it very cool, it took 6 and a half hours to print a standard cat, as I understand it, this is normal for 3D printing, but it takes a very long time for me. In general, it is not as noisy as many people say, but it’s not to say that it works quietly, it buzzes, whistles, blows) The thing is cool not only for home, but also for work, assembly is quite simple, but there are questions about the instructions, I had to use youtube. The set includes very cool mini assembly…