🔌 LANMU Micro SD to SD Card Extension Cable Adapter: Compatible with Ender 3 Pro/Ender 3/Ender 3 V2/Ender 5/Monoprice Mini 3D Printer/Anet A8 3D Printer/Raspberry Pi/GPS/TV – 9.8in/25cm Length Review

I have to unplug and reinsert every time I insert an SD card which defeats the purpose of this card as they protect against wear and tear during insertion and removal supposed to be a micro sd card. I should take a closer look, it could be a software issue, but I doubt it is. I've read that some of them just don't work the way they should. I would go back but didn't have time to when I first started using it.

Got this for my Raspberry Pi4 as I have to disassemble the whole case every time I want to change cards for a different OS. All my maps work and load correctly, but I could not get any of them to work with this map. The attached photo is what I get when I try to boot into Noobs. Not sure about other devices but can't recommend it for Raspberry Pi. Only gets two stars because it seems to be made pretty well, except for some reason it doesn't work.

I'm not exactly sure why almost every micro sd to sd adapter fails completely and ends up with a micro sd part that doesn't fully snap in, but when it comes around 3D printer goes There are inserts you can print out so they don't fall out and lock everything in place. Someone must have made enough of these to completely flood the market for the next 20 years because I haven't seen a single adapter actually lock up like a standard SD card. A bit strange, but not a violation of the agreement. I…

Works great with my Ender 3 Pro but no longer recognizes the card eject. More of an annoyance than a problem, I just have to select 'Change Media' from the menu and then 'Print from Media' to print. I flashed my Ender 3 Pro with the latest version of Merlin, so I can't remember if it's included in the stock firmware. For the price I would buy it again. I'm planning to switch to Octoprint from a Raspberry Pi, so this Ender 3 mod won't be of much value at this point (main reason is to prevent the

Bought two of these to make it easier to use removable media with my 3D printers (use SD form media instead of miniSD). They work. This is important. Pretty ambiguous. I had a hard time finding the location of one of the media slots. This "extension" allows me to eject/load media from the front of the printer instead of trying to go around the side to eject/load the media. That was the thinking behind the purchase and she does it very well. I have no idea how well it will hold up over time, but