Laser level ADA instruments CUBE 3-360 ULTIMATE EDITION (A00568) with tripod Review

Article No. 674664 Laser level ADA CUBE 3-360 is a compact builder of three 360° laser planes. Thanks to a special emitter, horizontal and vertical beams are projected 360°. Three mutually perpendicular planes allow you to perform absolutely any markup. Ideal for building or renovation work indoors and outdoors. Convenient markup. The level projects three planes: one horizontal and two vertical lines. All lines have a 360° sweep. The marking beam will be visible at any point. It is no longer necessary to rotate the device. It is enough to install ADA CUBE 3-360 at the chosen height. Turning on vertical lines results in planes intersecting at an angle of 90o. Very handy when leveling walls and corners between walls. Laser lines can be turned off one by one, leaving only those necessary for work. Precise alignment. Leveling is automatic. ADA CUBE 3-360 is highly accurate - the error is only 0.3 millimeters per meter. Two attachment points. The ADA CUBE 3-360 can be attached to a tripod or wall mount using a 1/4" screw connection. One thread is located on the rear wall of the device, the second - from below. The device can be mounted on a tripod or on a universal mount. Protected body. The entire body of the ADA CUBE 3-360 has tread protection on all sides. Rubber pads protect the device from damage during falls and bumps. Work from the charger. ADA CUBE 3-360 can be powered by conventional batteries, accumulator or charger. If the accumulator or batteries are completely discharged, the ADA CUBE 3-360 level can be operated from a charger connected to the household network. This will charge the battery. When connecting the charger, there must be no non-rechargeable batteries in the battery compartment. Lithium battery. For continuous operation, a lithium-ion battery with a capacity of 2000 mA is included in the kit. Incline work. In this mode, you can tilt the device to any angle. It is enough to fix the pendulum by setting the power key to an intermediate position. In this case, laser beams with the necessary inclination will be projected. Such a function may be needed, for example, when installing a staircase railing. Receiver mode. To work in bright light, on the street, there is a mode of operation with a receiver. When this mode is enabled, the marking distance increases from 20 meters to 70. Universal mount ADA BASE (MAGNETIC LIFT + WALL BRACKET) with microlift for size