Header banner
Revain logoHome Page
leadtops flexible headlight waterproof decorative logo

LEADTOPS Flexible Headlight Waterproof Decorative Review

5

·

Poor

Revainrating 3 out of 5  
Rating 
2.8
💡 Accent & Off Road Lighting, 💡 Car Lights & Lighting Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to LEADTOPS Flexible Headlight Waterproof Decorative
img 2 attached to LEADTOPS Flexible Headlight Waterproof Decorative
img 3 attached to LEADTOPS Flexible Headlight Waterproof Decorative
img 4 attached to LEADTOPS Flexible Headlight Waterproof Decorative

Details

Light Source TypeLED
BrandLEADTOPS
ColorWhite/sequential yellow
Manufacturer Part NumberLEADTOPS-HSL
PositionFront Outer

Description of LEADTOPS Flexible Headlight Waterproof Decorative

EASY INSTALL:It can be installed without open the car headlight assembly. Lumen:1300,Pure high brightness,highlight seamless,import lights core,quality assurance, heat dissipation quickly,lasting lighting, As running light, it will be white when the car is running; as turn signal light, it will be sequential flowing yellow(amber) sequential when the car is turning. 🧡Notes: Use glue to stick the joints for better waterproofing. ACCENT DRL AND TURN SIGNAL: A striking white liner look with turn signal actiavated amber lights. Flexibility is very good,soft and easy to make any shapes and length to fit into your headlight retrofit;Very strong plasticity,silicone is a kind of highly active adsorption material,the strip light no matter how twisted recovery is very good,non-flammable fire retardant burn. BENDS TO YOUR WILL: Can be bent, twisted, and contoured to fit most headlights. The LED Strip Tube Lights can paste outside of the headlights directly without disassembling the headlight,super easy to install,just require right connect to the positive (+) and negative (-) side, It can be cut to any size and re-capped,after cutting, the tail must be insulated, otherwise it will be short-circuited. Simply splice into your current DRL and turn signal wiring. Important Notice: Amazon filter system may not be 100% accurate, the bulb size may vary between trim of your vehicle. Please double check owner’s manual or original bulb size to confirm before placing an order. 60cm in Length,and Cuttable every 3LED Beads (must seal the tube with Insulated Glue for Waterproof Protection). The led tube light can be used for car headlight, daytime running light, turn signal light, angel eye light, and so on. Brighter and clearer than the original halogen lamps of your car. Compatible for most of vehicles like cars SUV vans trucks boats with DC 12V power.100% REFUND within 30 DAYS and 12 MONTHS FREE REPLACEMENT, NOTE:Any problems,please send e-mail to us at first time!!!.

Reviews

Global ratings 5
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    2

Type of review

Revainrating 5 out of 5

Love it. Stunning effect of the indicators

Big fan of DRL. I put them on the top edge of my headlights but didn't go to the top (as you can see in the picture) as that would require removing the headlights (and bumper) but I like the effect and line of the lights, as they are. As an added bonus, when the turn signals light up (unlock/lock/rotate etc) the white color changes to a yellow that extends from the center to the edges. Definitely not as bright as stock DRLs, especially on a bright sunny day, but otherwise worth the money :)

Pros
  • Satisfied so far
Cons
  • Everything is fine

Revainrating 1 out of 5

Have duct tape ready.

I like the way they look, my first complaint would be the odd little pin connector at the end of the cable. This connector would be useful if I had the other end then I could easily make an adapter to remove them and throw them in the trash when the tape is completely out of service. I used 70% rubbing alcohol to give my headlights a thorough cleaning. Everything was good, it looked great. The next morning both sides hang evenly. I waited for the dew to dry, reattached the strips, and held them

Pros
  • Great Price
Cons
  • Speed

Revainrating 4 out of 5

Ford Explorer XLT - 2011 Installation

Depending on the surface, the two-adhesive joint may or may not fully adhere. I had no problems with the top of my lantern, but I had to bend it 90 degrees to go down the side a little, and the curvature caused it to start pulling light into that side. I came back with some good silicone and put some foam on top to hold it in place while the glue worked and all is good now. You can't expect a dual stick to stick to any surface. Now that it's in place and connected, it looks amazing! The…

Pros
  • Pretty Packaging
Cons
  • Contact Seller

Revainrating 1 out of 5

Not flexible and glue is useless. failure after one month.

In the promotional photos these lights are almost at right angles which is impossible. I wanted them to follow the contours of my stock 2019 Toyota 4Runner headlights. Judging by the photos it should have been easy. Tried and nothing. Therefore, bend it as much as possible to follow the lines, so to speak. Before installation, I cleaned the headlights with glass cleaner. It looked good so it's fair to say it's good for the night. Came out the next day and the headlights were hanging off the…

Pros
  • Impressive
Cons
  • Only available in white

Revainrating 3 out of 5

Amazing LEDs, bad cables, bad controller, bad sealing (and lack thereof)

Overall good, but there are major flaws. Advantages: - VERY bright shine even in daylight. A little painful when looking directly - Good color temperature, not too blue - Consistent I like - Slim and easy to install. I disassembled my case, but it is not needed, you can glue it from the top / bottom. I just wanted a more personal look. Cons: -Return from yellow to white LEDs is VERY SLOW! Takes about 2 seconds, most other kits take 1 second and OEM is almost instant. Super annoying. I took my…

Pros
  • Test for a year
Cons
  • Repair