🌈 LEDENET RGB W WW 24V Flexible LED Strip Lighting Full Color Changing Adjustable CCT, Cold White Warm White RGB LED Tape Ribbon Lamp 5m 16.4ft Long Non-Waterproof Review

The LEDs are very bright and you have a wide range of colors and shades of white to suit your mood and decor. Highly recommended and great value for money.

My wife accidentally ordered a non-waterproof version but damn these things are light! I connected them to a Gledopto RGB-CCT controller and connected them to my Hue system. So far so good in terms of stages, discos, etc. Hue sync isn't currently compatible, but ScreenBloom on Windows and Mac does.

Received the strip and plugged it in straight away - unfortunately part of the strip was not properly connected resulting in the green and red LEDs being swapped. The rest looks great. EDIT: The seller was quick to send a free replacement and found that they are still working on some manufacturing defects. The new one looks great and works great with the Gledopto RGB+CCT controller.

At first I thought these lights are great and work great with milight ls2 controller. I've been wearing them for a total of 15 hours now, not right away but for the past week. The diet is correct, in an open space with a lot of moving air. They feel cool, but multiple diodes on the same light strip stop working. I think that's what you get for $30.

LEDs are bright, WW produce full white spectrum. The wires are not in the same order as the controller. I only found ONE 90 degree connector, but it only controlled the W bulb, not the WW. It didn't properly control the color of the LEDs: IE red on one side, pink on the other side of the connector. Since I already cut it out, I glued 2 short LED strips that cannot be connected to each other with a connector. Can only be used as a single strip. However, entire strips can also be connected to one

I was a bit disappointed when I found out that these are strips soldered together. I expected it to be a single strip that I could cut and splice to suit my setup. I found that I had to cut a lot more often than I expected to avoid soldering. I now have about 70 inches left of 6.5 to 13 inch pieces. I tried removing the solder with the iron and copper braid but couldn't get the edge into the wire extension. Lamps work well, but the way they are made creates a lot of waste.

They look great and are very bright. There is nothing more to say about LEDs as that is what they are and they do it. They are very easy to break. Lighter than others I've used. I had several issues like wrong colors or LEDs not turning on. It was entirely my fault for bending and peeling them off once they were glued to the wall. The tiniest crease or tear in them after they've been glued to something will cause the paths to break or cross each other so you end up with a partially dead or…