Header banner
Revain logoHome Page
πŸ”’ crawford 18025 25 pack industrial hardware locks for hooks by lehigh group logo

πŸ”’ Crawford 18025 25 Pack Industrial Hardware Locks for Hooks by Lehigh Group Review

3

Β·

Terrible

Revainrating 1.5 out of 5Β Β 
RatingΒ 
1.7
πŸͺ Hooks, πŸ”© Industrial Hardware

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”’ Crawford 18025 25 Pack Industrial Hardware Locks for Hooks by Lehigh Group

Description of πŸ”’ Crawford 18025 25 Pack Industrial Hardware Locks for Hooks by Lehigh Group

Clip these peg locks over peg hook, locking them into the pegboard holes on each side of the hook. Can be easily removed by inserting a thin blade behind one arm and gently lifting. Compatible with most standard peg hooks on all standard 1/4" and 1/8" pegboards. Keeps peg hooks from falling off the wall.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

The clamps are too wide to be used on a standard rosette.

These clips are too wide to fit in the standard white bezel I bought from Home Depot. As such, they are completely useless.

Pros
  • Slide these locks onto the hook and latch into the holes on each side of the hook.
Cons
  • Not fashionable.

Revainrating 3 out of 5

Please only 2 at a time!

They work fine. If I have a 1/4" Masonite hole board and use 2 pins per pin, they hold the pin securely. One per pin is more or less just for looks. You need to find 2 things and pick them up off the floor. You need to at the Be a little more careful about placing your pins as they are a bit more difficult to remove with two people.

Pros
  • Prevents hooks from falling off the wall
Cons
  • I'll add later

Revainrating 1 out of 5

Poor design, won't stay in place

differ from the previous design from the same manufacturer and although was the original design perfect, these new ones are completely useless. The two ends of the clip should click through the holes in the perforated plate and stay in place, but for some reason this design has a very, very reduced size of the part that is held in the hole, so small that it doesn't that's holding at all. I've tried them but they keep falling off my panel and literally don't do what they're supposed to do…

Pros
  • Compatible with most standard lever hooks on all standard 1/4" and 1/8" hole boards
Cons
  • Some minor things