🔌 Litever 90 Degree Corner Connectors for Litever Slim V Shape LED Strip Aluminum Channels, Includes Screws - LL-016-90D Review

they went up quite smoothly I would give a recommendation for the 90 degree reversed corner connectors the corners are great for going around the edge of the house took a look but some trouble for 90 degree turns going in the opposite direction. You can get it to work, but it would be a lot smoother if they had opposite 90 degree connectors. So the only reason I didn't give it 5 stars when installing it.

Connectors and corners perfectly match the aluminum channels for the Hon products I have. The manufacturer claims they're only for Litever products (which is perfectly reasonable), but they both list the same dimensions. It turned out that the tolerances of both products are good and they fit together. My only problem is that I need some corner pieces in an inverted configuration. (I would like the lights to point into the inside corner) but these are currently only made and provide the other…

Well since there is no way to formally ask a question about this product I guess I'll use that. Bought for a neat attachment to the outside edge of a table, unfortunately not possible. There seems to be only one way to make these connectors, and that's for internal bends, not routing on the outside of something. This may seem confusing but the picture shows how the rail is assembled and how the connector is attached. I can't find the right product for my needs and I have no way of contacting…

I just did some interior work with these V-Channel diffuser stands. They are supplied with corners and support brackets (centre channel). My advice is to kick out the middle channel supporters. They make the installation look like crap. corner details. I like them and I will share the best experience. Before you put them in the corners (which is the first part of the job) take a razor and join the tips together so if you need to run light through them it's MUCH easier than putting in the whole…

Purchased in case you need additional connectors in addition to those supplied with the main product. Once installed I don't even notice the connectors other than the 90 degree angles, I used them instead of the ones that came with the rail. The ones that come with the kit only have one screw hole. The way I have to install them I can't install the connector myself. Because they have two holes, I can place the connector on the raceway and screw it in without much effort. . One thing I would ask