🔍 Magicalmai Inductive Hour Meter: Waterproof Hr Meter for Gas Engine Generator/Lawn Mower/Pressure Washer/ATV/Outboard Motor/Dirt Bike/Motorcycle - Yellow Review

UPDATE: Although this product didn't actually work, the company quickly contacted me and refunded my money. Actually I will buy it again and try again. I will update it again in a few months. This product was on my generator. He accurately counted up to 40 hours. reset at 40 for some reason. Now it randomly resets every few hours for no reason. Ironically, I'm just outside the 30 day return window. So now I'm clinging to this useless piece of junk. I'll contact the manufacturer and ask for a…

Fairly easy to install. I installed this on my 2000W Champion Duel Generator. I made him a simple removable tray out of scrap metal. However, I could mount it on the top or side and just thread the wire through the plastic just as easily. The end of the sensor wire is wrapped around the spark plug wire 6 times and tightened with a zip tie (included). The other end (after you have routed the cable) is then inserted into the slot on the back of the meter. I left some length (so I could remove the

Honda crf 150r. This motorcycle has a coil in the spark plug wire. It's hard to explain, but if you wrap the included inductive pickup wire around the base of the "spark plug wire" where it touches the valve cover and secure it with some tape, you'll be fine. On the CRF 150R, you can't wrap the wire for this hour meter around a traditional spark plug wire, it's just a small wire that starts the coil that's actually at the bottom of the head (ignition coil). I promise it's not as mundane as it…

Bought a pair of these to use on 2 small inverter generators for recommended oil change maintenance. I thought they did a great job so I bought a third one and installed it on another generator. A sensor cable is supplied which needs to be wrapped and secured around the spark plug wire and the other end inserted into the groove on the back of the generator. Meter. I then used the screws provided to attach the gauge to the orange generator by threading the wire through the hole I had drilled in…

I ordered these to keep track of both of my generators. It's simply impossible to track time consumption without writing it down. With these hour meters, I can now accurately track run times for oil changes and scheduled maintenance. The hour meters are very easy to install. Simply route the wire from where you want to mount the gauge to the spark plug wire. Wrap around the spark plug wire at least 5 times and secure with tape. Peel off the adhesive film from the hour meter and stick it in…