💨 Enhanced Blow-Out Bulb for Makita Power Tools (765009-6) Review

I need a way to clear drill holes for concrete anchors (Tapcon screws). Unfortunately the tubing on this lamp is about 1/4" but you drill 3/16" holes for the tapcon so it won't fit. The manual for the Makita hammer drill actually says to use this blowball to drill these anchors, so it's frustrating to me that it's too big.

So I bought a powerful electric fan, but it produces too much wind and blows the earth to hell and is gone. I needed the equivalent of human breath, and this thing does it. The shaft diameter is a bit too big to get very deep into the bottom burr which is almost impossible to remove on my 860 Breville Barista Express which sometimes strays thickly where it's not needed, but by and large that's what it takes .

Overall, blowing dust out of a hole drilled in a cement floor worked, but there was an unexpected downside. The lamp inhales a small amount of dust each time it is flushed, and its performance has been found to deteriorate. Once I figured that out, it was easy to fix by simply pointing the tube up and quickly squeezing and releasing the bulb until the accumulated dust was removed. It helped if you tap the bottle during this process to make the dust stick to the inside of the bottle. I would buy