Maxmoral 1-Pack Dual Fan Mount PCI Bracket Holder for Video Card DIY Support 9cm/12cm Fan Computer Radiator Review

Overall this is a decent mount, very sturdy but still a little wobbly due to the weight of the fans being supported by just one mounting slot. The only problem is that since this bracket is thick enough for regular 120mm fans, it occupies more than one expansion slot, but instead of just using 2 slots in the bracket, they made 1.5 slots out of it. You could use 2 slots to better support the fans and improve the look as it would actually fill 2 slots instead of just hanging halfway in one slot…

I love the fact that this mount can use one or two fans. I bought a used Sapphire R9 Nano to replace my graphics card. About two months after purchase, the fan died, but the card continued to work, but got a little warm. To cool the graphics card, I used a Maxoral Bracket in combination with a be quiet Silent Wings 3 120mm fan. The fan runs at full speed all the time because it is controlled by the mainboard. My R9 Nano typically tops out at 101 Fahrenheit at peak load and 87 Fahrenheit under…

This is a fan bracket. It is suitable for fans and computer slots. Good material strength. Handy for installing under a graphics card for extra cubic feet per cooler. Helps to "swirl up" the air in stagnant zones. Very useful vertical slot for graphics card cooling. Listen, if you put a flimsy IE fan in this mount and it doesn't cool your fusion reactor, aka some graphics cards, don't blame the mount. Use decent CFM fans with decent case cooling and it works fine. Don't forget to replace the…

Used with be quiet! Pure Wings 2 fans under GTX1660S as standard GPU fans are too loud. I set the Pure Wing fans to 70% over the MB and used MSI Afterburner to set the maximum GPU fan speed to 60%, which runs about 5 degrees lower under load, but it's fine now. Installing the fans on the bracket was easy, but there was quite a bit of work to be done on the case. Had to undo the GPU and other PCI mounts to install it properly, tight but worked pretty well.

Fitting a fan with this product requires you to know how to convert centimeters to millimeters. I had confused a customer that this was the wrong size. All descriptions of this product should be given in mm, not cm. Anyone using this product should be aware that 120mm fans are the best. The flange holds all the weight to allow for placement and support. Also, be careful of the cables from your fans or from the motherboard that come into contact with the fans. Works very well with backlit fans…

I used this to install 2 Noctua fans geared towards my GPU and it didn't reduce the max temp. It's a shame, but the mount itself works well. There is no sagging and it is stable. The included drill bit screws are not the best screws I have ever used. I found it easier to drill with the included Noctua screws, but they are strong and drill quite well.

I really like the idea behind this product but the holes just don't match. I gave them the benefit of the doubt and ordered a 140mm kit hoping the holes would be further apart. To put them on my 120mm arctic fans. They still didn't fit. Tried Deepcool and am no longer a fan but still didn't want to go in. What I had to do was align a hole as precisely as possible, screw the screws in at an angle until they stop, then drill a hole in the other fan and tighten it with a screwdriver. It's not…