🔍 Maxshine 5-inch/125mm Clay Polishing Pad - Enhanced Clay Bar Pad/Disc with Applicator Review

Significantly reduces the duration of paintwork disinfection and also reduces hand fatigue from gripping a clay bar. Break it on the glass, keep it WELL lubricated at low speed with little to no pressure.

This thing does its job really well, it's easy to hit the bumper but it rubs off the paint which is normal as you should probably repair after painting, only one Another gripe is that it's only good enough for one car, as the velcro strap detaches from the foam padding with too much use.

Bad. Just like this one. I bought pads for 4500 or 50.00 and wondered why they are so expensive. then i bought this one. now i know why Poorly made and the material just doesn't do the job. Don't waste your money. Buy yourself a good one instead. Expensive but better. It's good that I also had an old one who helped me finish the job. It's in his shit.

This clay block does the job, but you can tell immediately that it is of poor quality and not very durable. It does its job, but if you want to put in less effort and get a quality product, I definitely recommend looking further. My $25 red Griots sponge with clay works better than this one with polish and seems to hold up better.

but works great and is a lot lighter than a clay block - at least for large and easily accessible areas. For small areas like between the wing mirror and passenger window or in square corners, you still need to use a clay bar as the rounded trim strips don't reach and clean. Be careful when drying. I made the mistake of laying it flat on a piece of cardboard and after it dried it stuck to it! Luckily when it got wet it came off safely. face dry.

Professional refurbishment I figured that by using a reputable product and not just a pop up brand here at Revain I would be getting a quality product. I was so wrong about that. When I first used this product it became sticky and started leaving black streaks. The surface of the car wasn't even hot! It's just that the normal back and forth motion of the da machine at speed 1 caused it to get hot and sticky and become unusable. Have better luck with other unknown brands here. I suggest avoiding