🚦 MaxxHaul 80685 Universal Square 12V Combination 38 LED Signal Tail Light - Optimized for Trucks, Trailers, Boats, Jeeps, SUVs, RVs, Vans, Flatbeds - 2 Pack, Regular Review

1997 Jeep Wrangler SE (TJ). The wiring was green with a black stripe and connects to the turn signal. White with a stripe goes to the rear light and solid white to the brake light. I routed the ground wire through the wire hole and out the bottom of the rear fender. I sanded the spot to ensure a good bottom and attached it to the chassis with a self tapping screw. Installed with a 50W, 6 ohm load resistor on each fixture. (Green/Black stripe to ground) No fast blinking. The lights are bright…

Work perfectly and are very bright. There is no left or right as they are both the same (lower license plate light and no side marker light). The threaded studs on the rear are molded into the plastic backing, so you have to drill the existing holes in the tub where the standard 1/4" self-tapping screws were. I installed them in a set of Rugged Ridge taillight guards and I had to just cut about 1/4" the length of the studs to insert into the shields. There are no instructions as to what color…

I ordered these to upgrade the lights on my Jeep. You'll need to do some research to ensure you've connected the wires from the car to the correct wires on your new headlights - there are plenty of places online to get this information. My old headlights were equipped with three threaded bolts that screwed into the body. The new headlights have studs that protrude from the back of the headlights and pass through the body. The rivets are larger than the original holes. On the left side I just…

Excellent value with an easy to install LED taillight kit. Clear and bright light, not gaudy like some LEDs. Looks like it's made from quality parts and is as durable as the OEM. A clear improvement over the standard headlights. Installation took less than 1 hour with a Phillips screwdriver, 3/8" socket, wire stripper/pliers/pliers, 22 gauge splices (red), ring terminal, and electrical tape. The studs on the LED lights are slightly larger in diameter than the standard mounting studs, so the…