Metropolitan MB 3CDSWB Blaster Revolution Motorcycle Review

A must if you want to clean your car as contact-free as possible. Hold tight. If you lose the hose, the force can blow the hose onto your car and leave a scratch.

Works great on all types of vehicles and saves a lot of time. I can dry everything under the hood, even after pressure washing. Even works great on a 90lb German Shepherd after a swim or when she goes out in the rain, she loves it.

High performance, excellent performance with one or both engines running. With two it gives off a little heat for excellent air drying when rinsing the car. Note, however, that both motors draw very close to or at 20 amps. Most household sockets are rated for 10 amps. Luckily I purposely wired 20 amp outlets in the garage.

Rugged, superior performance with either or both motors. With two, it generates some heat for excellent blow drying when rinsing the car. Just remember that both motors are very close to or draw equal to 20 A. Most household outlets are rated at 10 A. Luckily I wired my garage outlets at 20 A on purpose.

So far so good after the first use. Blows a lot of air, pretty quiet. The air itself entering the car is much louder than the fan. I ended up using headphones. Be careful when installing or removing the "nozzle" while the fan is running. Keep the end pointing away from the vehicle. Learned this lesson on the first day (fortunately without damage). I don't think I'll dry my hands.

I've wanted one of these Master blasters for a long time so I saved money, looked for a good deal and ended up buying the MB-3CDSWB which came with a 10ft blaster. hose and then on another site I found a 30 foot hose at a killer price and between the two I got the whole deal for $350 (a killer deal). Now, at this point in my life, I have 4 show cars that I show regularly, plus "Ford Fusion" and "F350 Crew Cab" as daily drivers (both are black) and here's the best part: I've got mine Master uses

I've seen so many conflicting reviews of the Metrovak online - and after months of deciding whether to buy it or not ,I finally got it I used it a few hours after it got to my house!Assembly was very easy.All you have to do is attach a hose to the vacuum end and tighten.I read that this section addresses itself loosens for some people during use - so I recommend making sure the clamp is actually pulling the hose to the machine's connector.The dryer was reasonably safe in a paper-filled box and…