Enhanced Conductivity Carbon Grease by MG Chemicals Review

I had a problem connecting to the 240V network, fuses often blew. After determining that the problem wasn't overcurrent (I measured it with a current clamp) but rather overheating of a not-quite-strong connection (I heard tiny arcing noises), and the next fuse heated until it blew, this product was the solution . After carefully cleaning the wire of carbon deposits, I liberally applied this grease to the inside of the connector and tightened everything up as tight as I could. The audible arcing

If you have problems with disconnects in connections exposed to the environment, I recommend this product. I repeat that a very small amount of this product makes a big difference. Don't pick it up because it's sticky and difficult to remove without lots of dish soap and a scrubbing brush. I have used it in connectors that are exposed to the elements under the hood of a car and I use a wooden toothpick to take a small amount of this product to rub the inside of the socket and then assemble the…

If you have an old Volvo with a bulb integrity sensor, you know my pain. Due to the age of the car (30 years old) the connections weren't tight enough due to all the vibration it had to endure. The bulbs in these older cars are held by a bulb holder which then pivots/snaps into the holder/bulb combo housing. There are many places where the chain can break, or even a little wear/corrosion will cause an intermittent connection. After cursing my car for a very long time, I applied some of this…