Mlife Mini Heat Gun Dual Temperature Painting Supplies & Wall Treatments Review

I bought this hair dryer to use in making candles. I turn it on and use it for about 10-20 seconds and then turn it off. If I try to turn it back on within the next 30 minutes, it won't turn back on. I disabled it to see if it would reset something internally, but no luck. I can basically use it every 30 minutes. I've just come to terms with the fact that I have a vagrant heat gun and come to terms with it because returning anything with Revain is a nightmare these days since there aren't any…

Ideal for reducing bubbles when working with resin. While it doesn't clean everyone and splatters resin all over the place if you hold it too close, I still like it. As I continued to work with this tool, I encountered some problems that most likely could have been avoided. Since resin is difficult to work with due to the ridiculous stickiness and mess, I've now coated the heating tool's on/off buttons with hardened resin, rendering it useless. This is something to keep in mind when using the…

The lowest setting will move the resin if you hold it in one spot for too long, but it will take care of the air bubbles and remove/lift them to the surface. I've never had to use higher settings as lower settings work just fine. I only use it at 3 minute intervals, and with a maximum run time of 15 minutes, that's enough to get the job done. I have no way of seeing what temp it's blowing at but it gets warm and the nozzle can be hot so be careful but the area you're holding doesn't get hot or…