⛽️ Motion Pro 12-0036: High Quality 5/16" Inline Fuel Valve for Smooth & Efficient Operations Review

Matches my full range perfectly on my Johnson 150. It's the 16.5. Now I can unlock the engine when I get home. Fast delivery.

Installed as a backup valve for the vacuum valve on my Suzuki DRZ400S a month ago - works great. Seems solid and well made.

Did the work on a much needed check valve for my snow blower. There is no more gas smell and now the carburetor is empty and still has a full tank of gas. Highly recommended.

This is a quality Motion Pro valve assembly. clearly marked. The handle has a smooth finish and is fixed in the open and closed position. money well spent.

First, the hole in the valve itself is much smaller than the hose portion of the valve. The actual hole is 1/4 inch, not 5/16. My applause was a 55 hp tractor. Although it would be a good valve for a small engine.

I bought a pair of these valves to replace a pair of check valves I installed on my boat last year. They are more durable than the old ones that leaked a bit when switching from off to on when the tank was pressurized on a hot day.

Product leaked. My pants smelled of gasoline. I figured I might have loosened the bracket to make sure the hoses lined up and the clamps were properly attached. It was still leaking. I thought I was being too rough with the clamps on the hose so I replaced the top hose. Still leaked. I thought it might be the spring clips so I replaced them with old fashioned screw type clips. Still leaked. Took off the MotionPro valve and installed the ugly loose fitting in-line filter using the clamps…

Excellent rooster. A typical combination of quality and value Motion Pro. Critical components such as the toothed T-bar and the locking ball bearing are made of brass or steel with a high-quality zinc coating. The "handle" is plastic but feels good, well made, like ABS or Delrin - not a cheap feel at all. The most important thing is that it does its job and I really like it when there is a built in petcock and I don't have to fiddle with the installation anywhere. Don't believe the hype around…

Very good valve - I've seen it not recommended for cars over 300cc. no issues or problems so i bought it for my KZ550 as the stock vacuum tap leaked at times and used that as insurance (better safe than sorry and such). The problem is that the main valve body is steel not brass and the walls of the serrated joints are quite thick so even with a 5/16 (8mm) fuel line there is still a limitation as the inside diameter is reduced. a lot of. I haven't had any fuel issues yet, but I haven't ridden…