🚀 Enhanced Performance with Mr. Gasket 6039 Throttle Cable Bracket for Your Vehicle Review

Cheaper than Auto Zone or Oreilys, pretty beefy guy, no instructions although I installed this on the back of my four barrel Eldebrok.

Quick service, also accommodates two different shifter cable connectors, very strong construction, must be bolted to rear of Q-Jet carburetor. Holly or other carbs, I don't see a problem. I will buy more for motor mounting.

This may sound silly, but instructions or even a picture would be nice. For a while I was frustrated and thought it wouldn't fit my carburetor and many others. However, after digging around on Google, I found that I was just being stupid about this. Of course I'll admit that this was my mistake, but this could have been avoided by simply including the original packaging.

The computer and wiring harness were junk on my '88 Dodge D150 so I got a cheap one Stepping out, replacing the manifold with an earlier model and adapting an Autolite 2150 carburetor to the throttle body inlet. Of course, as my old friend Wooley always says, "Every solution creates a new problem." And that problem was fitting the Dodge throttle and kickdown cables to the Ford carburetor. With the use of aftermarket cables and looping about 1/8" of Mr Gasket in the round hole I was able to get…