MUYI 2 05Inches Motorcycle Filters Kawasaki Review

This is an updated review. Finally, I went for a bike ride, and one of them immediately fell off the bat. It ended up being destroyed by either my rear wheel or the car behind me. After re-reading, I realized that this is very, very common, the seller knows about it. Instead of giving me a new one, the seller was kind enough to give me $4 back. Unfortunately I can't buy a new one to replace this one. The seller should repair their product and not expect buyers to actually glue their parts…

Filter received on time. Delivery was quite quick and as expected. The problem with filters, however, is that they detach from their own rubber housing very easily. It's not so bad that I'll have a lot of problems sending them back, I'll use them because the filter is really good quality (comparable to K&N but half the price) and looks great, but . I need to put some two part epoxy between the filter and the rubber housing and I would advise anyone buying them to do the same as they will drain…

Like many others, these filters look great. Rotating the filter where it (barely) hangs from the rubber sleeve was disappointing. Even more disappointing is the TERRIBLE injection molding work and zero quality control. The edge that the filter has to cushion on the boot is very different for each filter. One of them falls off when the engine is started. Need to find a large radius pipe and stretch/heat it to make it safer. Also lift the trunk up to the carburetor (especially on CV carburetors)…

Advantages: Very cheap. They fit. Cons: Filters are branded "MOXI", I don't know who MOXI is or why they are sold as "MUYI". "MOXI" is embossed on the top cap, not just as shown in the picture. The connection between flange and filter is very loose. You will almost certainly want to glue them together. Each filter has holographic stickers that are almost impossible to remove. See attached photo, filter on the left. I spent a few minutes trying to get the sticker off. The top layer could be…

First, I love the look of these pod filters. Their design of the filter itself is top notch. It's way more durable than the standard crappy airbox filter. At 3,000 miles I was doing maintenance on my moped and removed the air box cover to clean and re-lube the filter and it broke up and stuck together in the air box! Sounds awful I know. These filters help to let in more air. My moped got louder, but not by much in my opinion. It also causes your engine to rev less, requiring you to adjust the…

I love these picks so much right out of the box, they look so well put together I installed two on a bike with a 39mm input today. At first I was a little worried about how the filter might rotate around the filter housing, as it rotates I think air is getting in as well. The situation gets much worse, the inlet ID is reduced to 27mm (probable flow restriction) at a distance of about 17mm or 5/8" from the edge of the boot to the filter itself. Bike with the hose clamp provided, it changes the…