🚗 NDRUSH Smoked Taillight Rear Fender Vinyl Tint Film Overlay for 2014-2020 Jeep Grand Cherokee - Precut Tail Light Wrap Cover Review

Despite some bad reviews, this product works as intended and is easy to install. I prefer partial blackout to full blackout.

Window film quality is exceptional! It even comes with duplicates in case you are confused. I definitely recommend using a heat gun with parts to make sure the jigs fit properly! and use plenty of soapy water to keep the movie playable throughout!

Best value for money. Just does the job well. In addition, the optics are fantastic! Upper taillights are the most difficult and time consuming, about 15-20 minutes to position and smooth the part to remove bubbles and wrinkles. I recommend to buyers, despite some negative reviews.

Good quality, fits very well, I want them to sell the right and left separately. They give you a training set. Mine had an extra left side so I made that side 1st. It worked great so I didn't need it. But I made a mistake on the right side. So now I have to buy the whole set for only 1 piece. But overall very happy with the product.

This amazing product is only $30. I didn't use backlight shades for personal preference. Some tips: be sure to use a spray gun to lightly mop up the glue, also use a hair dryer to get rid of those pesky creases, use the squeegee to remove bubbles, and most importantly, be patient! Don't think you can finish it in 10 minutes. Get ready for 30-40 minutes for best results!

Do they look good? Yes. Was it easy to install? Not the easiest. This includes a double for the driver's side. So start from this page. However, I had mislabeled some of the parts and they said they were for a light they obviously wouldn't fit, so it was a little confusing trying to figure out exactly where to go. They look very nice but the cuts on the edges are not perfect. But overall I'm happy with it.

Much easier than I expected. Straight parts, no curves, taillights on the back of the car, literally in a matter of seconds. But take your time and make sure everything fits together. But curved angle lenses took a little time. I first cleaned all areas with an alcohol spray before applying the tint. But the corner pieces, you should have a hair dryer handy, and heat a little on the curved area and stretch a little to conform to the curve. But the little thing is so important. I love the look…