🌞 Nilight - ZH001 20Inch 126W Spot Flood Combo Off-Road LED Light Bar + 2PCS 18w 4Inch Flood LED Pods - Wiring Harness Kit Included! Review

Works great. Very bright. It can be a bit confusing how much light it actually puts out. It doesn't actually consume 126 watts. I have many LED strips on my tractor that illuminate everything around me. If I turn them all on at the same time, the motor sound doesn't change. With normal headlights, there is a slight momentary downward pressure. Installation requires a minor design change to place it on a vertical surface. Points up or down. never straight Horizontal attachment to the face…

After reading many other reviews about cleaning assembly parts. A closer look reveals that the threads are partially filled during the powder coating process. I used a 1.0 6mm threader, this made installation easy and took maybe a few hours including cutting all the threads on the mounts. The wiring harness was perfect for my 2015 JKU. I used a 7/8" hole saw and installed the rocker to the left of the light switch lever. Very bright and for the price I'd say hard to beat. 4 stars just for the…

I installed this kit on a 2007 agco st22a subcompact car. This is the sister of the Massey Ferguson 2300. The kit fits perfectly. The cables were long enough to follow the factory wiring harness from front to back. The button was just the right size to fit snugly on the dashboard. I ended up using just one of the two smaller headlights in the back. The light it gives off is phenomenal. Definitely makes it easier to get around in the snow at night. I'm too impressed with the payout here. The…

Bought this set of three headlights for two cars. Two small lightbulbs struck our Scag zero turn lawn mower. I built the mounts and used the included switch. The light is nice and bright and the switch and wiring worked well with some lighting mods. The large "middle" headlight hit the "tall bracket" on the front of my 4 wheeler that I use for snow clearing. I had to set it high to stick out over the blade. I hooked it up to an OE high beam switch. I thought it would be a little lighter than it

Headlight installed in my small tractor. I had to make special mounts for a large light panel. I needed at least 180 degrees compared to the 45 degrees provided by the included mounts. Removed the side plates, drilled holes and used nuts and bolts to make a mounting point. Took 2 inches at a 90 degree angle from Wally's world and screwed it on. A switching station with 12V sockets made for easy use in case the lighting needs to be replaced. I used an old plastic tool box that contains my built…