Nilight - 15019S-B LED Light Bar 2PCS 18W Spot Driving Fog Lights Off Road Boat Lights LED Work Light SUV Jeep Lamp with 2-Year Warranty Review

I didn't like the way the mount attached to the mount. As others have pointed out, you have to put the bolt through the bracket, then the light, into a tiny area, and then through the lock washer and nut. The nut is the same width as the hole. The hex wrenches are too short, but I angled them to tighten the nuts and then used the narrow end to tighten them. I put a drop of glue on them so they don't come loose when they vibrate. You need to craft 4 of them. Otherwise the installation is quite…

So far so good. I bought them as extra reversing lights and wired them directly. So when I back up my jeep these lights come on too. They are MUCH brighter than the stock reverse lights and really help. I will refer to some things from other reviews.1. The mount is just too wide. This is probably the universal mount they use for all their jigs. It's ok, just bend it a little and it will fit.2. I haven't had the equipment long enough to see if we rust. It probably will. I can just paint it with…

The light output is fantastic however the fitting of the light can be awkward due to the small cavity which requires small nuts and bolts for assembly. You may need the tip of a screwdriver to keep the nut from turning for optimal tightening. Rest assured they will be tightened. The operating voltage in technical condition is 9-30 volts; not exactly, the maximum operating voltage is 20 volts. I installed them on my ATV, the lights are lit by the headlight switch. I didn't know the voltage…

Bought for my tractor. Pretty decent lights for the money. Just finished the install today. 4 of these bar lights front and back and four 4" spots on the sides. I'm fine with them. They're cheap so you might want to put them under your shed if you plan on putting them on a tractor. Put them sure they aren't waterproof. The strain relief/cord seal was pulled out and I didn't even pull on it. The wiring is 18 gauge aluminum so be careful. I've been doing this for years and know a lot of tricks…

Insanely bright - I bought 18 watt off-road fog lights - single row, 6.25 inches long and 1.75 inches high. I bought these as taillights for my Jeep Wrangler. I've installed a rear view camera and also replaced the stock taillights with JW speaker LEDs, but I still can't see clearly from behind. I tested them straight away with a standard 9 volt battery - photos attached - and they're insanely bright. I gave them a star for the hardware - the bolts aren't stainless steel and the threads weren't