⚡ Power up your Devices Easily with Nilight 10 Gauge 2 Pin Quick Disconnect Harness: Heavy Duty SAE Connector Bullet Lead Cable for Hassle-free Connections! Enjoy a Solid 2 Years Warranty Review

My 15 year old winch has broken quick disconnects and can't find any parts. A belt with two pins is what I needed. The winch attaches to my snow blower which is hooked up to my quad so hooking it up is super easy.

Perfect for making a solar panel adapter for our RV which came with a Zamp SAE roof entry box. After making sure the polarity matches the black wire, I cut off the other end and crimp the Renogy MC4 connectors to them.

As far as I've seen, this is the only 10 gauge quick disconnect with SAE connectors. I looked everywhere for a heavier caliber and this was the heaviest I found. I cut them in half and used them to quickly disconnect the solar panel from the battery.

Great product! Anyone who regularly needs to charge a device's battery should get one of these. Cut the loop in half, connect one to the battery terminals and the other half to the charger and you're done. No more disassembly to get to the battery. No more removing the seat to access the battery on an ATV or UTV. I have one installed on each of my tractors and solar chargers.

This 2-pin 10AWG connector can handle the load for connecting the e-bike battery to the motor very well. Of course it has other uses in the car stereo market but I chose to make all the engine to battery connections with this heavy duty connector and they work great. Good for 30-35 amps, which is about the power of an average e-bike geared motor. I will be buying more of these great value connectors for my next e-bike project in the near future.

I used this to install a quick connector for my inverter. It's a nice thick cable that does a good job of powering my 800w inverter. Installation Tips: - Cut the wire in half. - Connect the plug to the negative plug on the power supply side of your machine. This prevents arcing when not in use. Use good butt joints for full-length power/ground wires. Always use good quality shrink tubing to cover joints. connected it to the inverter. I also put a 20A fuse next to the power supply. Works…

I wanted to wait to write to see if I need it. I bought this because I was making a solar case for my 5th wheel. The fifth wheel comes with a ZAMP solar connector on the side of the trailer. After confirming (this is an important fact) that the ZAMP is set for reverse polarity, I swapped the plus and minus on my case (2 RENOGY 100W modules and a Victron SmartSolar MPPT 100/20 100V 20A solar charge controller with Bluetooth) and connected it with this quick connector. It worked great. Highly…

Our RV supports ZAMP Solar Ready and I use it as a pigtail between the RV and the solar panel connector cable to minimize the stress on more expensive cables. Most people know that the ZAMP patch cord uses the female end of the SAE connector for the positive pole and the male end for the negative pole, which seems like a great idea to mitigate a ground short when the cord is touching metal; however, this is the opposite of the polarity of the other system. If you use the correct end of this…

The connectors are excellent, strong connections. Almost all plugs of this type that you will find are very light. You'll see them for use with the Battery Tender and things like that. These can sometimes be purchased at your local auto parts store, but again they are small. I needed to power the rear of my tractor and needed a universal high current quick connect system for various accessories. They are perfect for that. Got an built in blade type fuse holder from Auto Z that was 12 gauge and…