Nilight Wiring Harness Waterproof Warranty Replacement Parts for Lighting & Electrical Review

:I didn't expect this, now you buy something and you can only hope for the best. Well, it turned out to be the best it could have been. The kit is durable, you can feel the quality right out of the box, packed with care. There were even a few extra fuses in the kit which is a nice plus. It also gives a professional look to my LED panel installation. Ideal!

I really like this harness. I was adding fog lights to my truck and wanted a professionally made wiring harness and switch to replace the switch that the previous owner installed. The only problem was that the wiring harness has a rather large connector to the switch that doesn't fit in one of the holes in the car's cabin. I end up cutting off the connector and putting it back on the other side. Works great but only gave 4 stars for installation.

Like a switch. The cables from the relay to the switch are too short. There is about 3 feet of wire from the switch to the connector and another 3-4 feet of wire from that connector to the relay. Not enough wire to get from the battery to get it through the firewall and down and turn on the dash. I ended up using the wire harness from a previous small lightbar that had a lot of wires and just plugged the wire from that connector set into the switch. It would also be much better if the crimp on…

Wiring and switch quality seems good but when trying to hook up the lightbar I actually had to make a trip to the local ACE device and extra wires because the length of the wire from the battery to the switch is only about 4 feet. This would be fine if your battery was on the driver's side, but that would shorten it. If your battery is on the passenger side like mine is, you'll need to run wires along the firewall, and they're not long enough to even operate a switch in the cabin, let alone the

I have finished installing the 14 gauge kit and I had a small technical issue. Through a quick chat with their tech support team, they were able to help me with a level of customer service that I never expected. About the kit. 1) The wires were strong and secure in all areas. 2) The kit had a very solid construction. and there seemed to be no areas using lower quality components. 3) The extra fuses were a big surprise. 4) The instructions showed two different and simple wiring options. VERY…

Attention buyers! I connected it to a 300W Nilight light bar. After lots of cables in the cabin, Tundra 2018, I connected it to the battery and immediately noticed smoke coming out of the cables. I immediately disconnected it from the battery before more damage was done. The wires got very hot and the wires to the switch melted. It's a good thing it happened while I was still in the engine compartment, otherwise it could have been worse. After some research, there were obviously others who met…

I think this is a solid kit for the most part. My son bought a regular kit and the wiring was a bit short and I can see it being possible on a full size extended cab truck. I even told him I bought the heavy-duty kit because I figured I'd need a longer wiring harness. Pfft, not even close. It is long enough from the battery to the switch in the cabin. But the wiring to the crossbar needs to be at least twice as long, and since the wires are already disconnected you will now be extending 4 wires

This is a great set of wiring harnesses. MAKE TIME! Watch some videos and familiarize yourself with a little basic wiring before you start if you've never done anything like this before. It's very easy to do, just take your time and plan ahead. Also, don't connect any of the connectors until you're absolutely ready! They stick very well and are difficult to break. If you're having trouble running wires through your car's wire bag, wrap the switch terminals in a single layer of duct tape…