🔩 NIUPIKA Precision Rotary Drilling Center Review

Works great but 4 stars due to inability to hold tools properly in place. You can tighten the handle to hold the racket, but it slips off very easily and hurts. If it slips off, it goes completely into the bit holder and is not easy to catch.

I have a diecast model of the B-52 that my father flew. I broke the plastic fuel tank on the fender (ARGHH). It was held in place by two plastic pins that broke. They had a diameter of 2 mm. I had to drill holes in the plastic blocked fenders and blocked holes in the tank masts leaving only 1mm clearance to the edge of the mast. I am older and very shaky. Well I had no problem centering the drill thanks to the included vise holding the tank in place. I greased the end handle of a hand drill and

I like the vise and the grip of the drill. I tried the drills on old plastic and they didn't drill. Luckily I had old micro drills and they did the job. For this reason I gave only three stars. I bought a micro drill set and it doesn't seem to be working as I expected. I'm sure I'll have to use bits again at some point and I'll try. If they work I will revise my review. The drill handle and vise are good and I will use them often in the future. They're pretty well made and will work for what…