🔴 1" ODI Vans Cult Street Motorcycle Hand Grips in OX Blood - Enhanced SEO-friendly Title Review

Love the look, feel and ease of installation. The throttle side has a larger diameter hole that is easy to identify. I dunked the grips in soapy water and they slid without much effort. They didn't slip even before drying. I didn't use glue, may need to stretch after them.

I bought these for my 1969 Sportster, I use the left and right throttle assemblies, one for gas and one for my magneto, used some soapy water and they slid to the right At. After drying, they do not move. I bought 2 sets thinking I would need 2 rights now I have an extra set for another build.

I liked the grips. I used an air compressor spray nozzle for the installation. I enlarged them by about 2 inches and stuck the tip of the nozzle into the small hole at the end of the handle. I opened the valve VERY slightly and the handle exploded like a balloon. Don't use too much air as this will likely overstretch the grips. The manufacturer may not recommend the installation method. 🤷‍♂️

I've bought these for every bike I've owned, most recently a Harley Sportster 48 Special. They look very cool, have a lot of grip and offer significantly more cushioning than standard grips and the price is right. Rubber breaks down over time and eventually wears out after a few seasons, but they are very easy to install and replace. I love the attitude they convey, while the black ones aren't immediately noticeable on the bike, once you notice them and see that they have the same grip pattern…