🚘 Pacer Performance 25-502 Enhanced Black Bumper Guard Kit - 4 Piece Review

While I lost one while driving, the 3M adhesive looks unsafe but at least it held in place for about 10 minutes. Not really, Dicke could be better. Not worth $30.

I LOVE IT. I actually bought these to protect the side panniers on my Honda Goldwing motorcycle. Prepare as directed and apply carefully. They have been on the bike in heat, rain and dust for months and still look and hold up well. They worked very well and I would buy them again.

This is the best. You're a good hard rubber and if you're good enough. If you're going around corners, consider putting extra double-sided tape between the strips. They were easy to cut and turn into a continuous 6 foot strip of rubber on the front and back of my Camry. And the end pieces I trimmed went into several projects including securing my coffee mug in the car.

They were perfect for what I wanted to use them for, besides a gloss finish I really wanted a matte finish. I took 500 grit sandpaper and rubbed lightly to remove the shiny finish and then used 0000 steel wool for the final finish. Replaced the tape with 3M form tape to ensure they stay in place. The finish is now matte and with tape on they will never move. Now it cannot be said that they were an addition to the bumper. looks perfect

Found these on the plastic fenders of my black Jeep Wrangler JK. It looks good for this car, but it serves a useful function. But they are big. The portion of the bumper that makes contact with the car is approximately 1 inch wide and protrudes approximately 1/2 inch at its highest point. After 6 weeks of installation, the 3M tape is still holding them well. I would buy it again for the black JK. However, due to their size, they are not suitable for all vehicles.

Place prepared and glued with alcohol. It's only been two weeks but they're through the car wash and I don't think they'll be out any time soon. One end doesn't seem to go in as much as the other end. If I knew that, I'd cut a small rib down the middle from the bottom. I think it would help. It is too late now that they are bound. You have to look for it to notice it. They look like part of the car and match my black paintwork perfectly. I would buy again.

Satisfied! The sticker sticks very well, contrary to some who claim it doesn't. I think they didn't clean the surface properly. What I did first was wash the surface with soap and water. I then dried and cleaned the surface with cotton pads soaked in alcohol, which visibly removed quick-drying grease stains. That's the whole trick. It would be helpful if the seller included this information in their products to improve the customer experience.

The gloss black look seems to go with my Mazda 3 dark gray quite well. It should be noted that what I received had some surface imperfections (rips, warping marks) - but I don't care, it's a sacrificial piece anyway. In terms of installation, of course clean your surface adequately, at least with a good cloth (I also accidentally added a layer of sealer/wax in front of my hand and apparently this makes future removal easier and maybe protects against minor scuffs). In terms of application…