💡 Industrial Electrical Pack with Reliable Receptacle Resistant Self Test Indicator Review

Works with solid or stranded wire. Clean the outlet pressure gauge. Keeping the wire straight, insert it into the hole provided. Holes are clearly marked and labeled. The hole guides the wire between the clamping plates. The wire is clamped with a stepped, pre-installed, non-removable screw. Use a flathead or Phillips screwdriver for a really secure and tight fit, with no exposed copper or kinked wires. The method is the same for neutral, hot, and ground wires. Fast, preset and easy. Don't…

Bought 2, doesn't fit. Some ants got into my garage GFC outlet and shorted it out. looked at amazon. bought 2 of them. changed and nothing. did not fall. another installed and nothing. I'm not stupid and I know what I'm doing. Couldn't believe they both could be bad. dismantled 8 sockets looking for problems. haven't found any. I've been doing this for about 3 hours now. went to lowe and bought 2. installed and started up in 10 minutes. What a waste of time to save $6 each. should have a hint…

I used it to replace an old almond GFI. The holes that are supposed to hold the wire don't work at all. They slide straight out. Not even a ground wire. I even cut and scraped and used a guide right on the back of the socket. no So I tried screws. One of the screws on the side of the outlet was not screwed in properly - it was skewed so the screw would not turn forward or backward. I used a different set of screws but they have lock nuts/washers on the inside of the plastic case. So if you ever