📏 Pencil CASE for Wyze Cam V2 – Enhance Discretion and Aesthetics with this Camera Housing Plus Pencil Holder (Compatible with Wyze Cam V2, Not for Wyze Cam Pan / V3 / Outdoor) Review

Bought to hide my camera in my living room. Happy because I can use it as a remote control holder to hold what's inside. I had to buy a black silicone case for the camera to otherwise hide it. The camera is white and completely translucent. Otherwise the part is unusable.

I didn't want the camera to be so visible on our robe so I turned the pen holder into a cute vase! The only downside is that you can't adjust the angle of the camera, so I just put a paper towel under the back edge to get a better angle! Works great and nobody notices 😁

Nice case but it places the camera too low and in some cases forces you to place it in a more prominent position for a clearer view. Later I ordered a case with a higher mounting position for the camera. As I mentioned in another review, it works better in a shady place so as not to expose the lens too much. Another good case.

what a handy product this is my wyze camera fits in so easily perfect for the camera i need to adjust for my mother in law who has dementia. We just stick some colors in the top and it will look like a vase. We were able to protect our mother-in-law and prevent her from turning her off and walking with the camera.

I like it for the more discreet Wyze camera setup. But that means your camera is lying flat on the table for the most part, so you see most of the table in the bottom half of your view. I wish there was a similar product that would allow for a higher seat cam. Also, I find it expensive for what you get. I think I could do something just as good.

Great pencil holder with eccentric Wyze body. The camera fits perfectly thanks to two holes in the front and a large square hole in the back. My only issue is that there is no spacer between the camera and the pens, so pens, pencils and other items end up on top of the camera. There's also no way to use the camera's built-in stand or rotate the camera to a different orientation for a more discreet look.

Not what I was hoping for. Came back with no problems. 1) The standard cable does not fit the 🕳 hole. 2) Product photos look like they cover the camera (the whole point) but there is no tinted cover over the camera area so only the black Wyze camera world exposes your camera. I have a good setup and it doesn't get any better than mounting the camera on a table or shelf (especially for the white camera as shown). The quality and fit are excellent; such a plastic box for storing pens ✏️ and a…

So I did that to make it less obvious that it's a camera. This does the trick and makes it less noticeable overall, but if you look at it for more than a few seconds you'll likely still notice the camera. You just insert a Wyze camera (I have v2) from the top and then connect it from the back. The camera is perfectly aligned with the notch on the bottom. When the camera is in place, there is approximately 4 1/2 inches from the top of the camera to the hole in the top. This is a gloss black…