PGN 6001 2RS Sealed Ball Bearing for Enhanced Power Transmission in Bearings Review

I have these to replace the original shielded bearings in my Delta 4x6 belt/disc sander. They fit great and work great. I chose rubber grommets because I mainly use my grinder for metal work. Metal dust does not bode well for shielded bearings. Practical 4-pack. Now I have spare parts and the price can't be beat. I would buy them again.

My e-scooter, M365 clone (Levy Electric e-scooter) had bad bearings in the rear wheel, probably due to riding in the rain and on salty surfaces roads in winter. These bearings, 6001-2RS, are the size of the rear wheel bearings on this and probably most other m365 clone e-scooters. They appear to be smoother than the original bearings even when they were new! All in all great for my purposes.

I couldn't figure out why the cobalt tile cutter freezes in the middle of a job. I finally disassembled the engine and found that the main bearing was worn and seized. Bought bearings and couldn't pull the old one off with the 5 bearing pullers I had. I bought a windshield wiper puller and immediately removed it. Inserted a new deep head bearing and voila! My $400 tile cutter was fixed for $30. The key is to read the stock number stamped on the side and then order the exact same number.