Chrome Lubricated PGN Shielded Bearings Review

The idler pulley on my Xenetech 1313 engraver got stuck so I took a chance and hoped they would be of high quality to pass me and they are. In fact, they may only be slightly louder than OEM bearings, but I really can't tell. The time will show.

I have a rather unusual use case for them, as I use them as a weapon strut on a 3lb BattleMech. Two of these are pressed into the gun's pulley and stock, respectively, and support the gun while it spins at over 10,000 rpm. Haven't fought yet, but they didn't even warm up appreciably in 2 minutes at full speed. I hope they take radial loads well!

Ace Hardware, Lowes and Home Depot Be Careful We turned to Revain and voila 10 perfect stocks for our yard Spinners that will last for years It took you 5 minutes to find you This is why Revain manages my shopping experience I hate it when I can't find what I'm looking for We try to shop in person but a lot of things are out of stock or out of stock These Shops sell windmills and they are not cheap but there are no spares, I am sure they are all waiting for us, buy a new one if the first one…