🚗 Pair (Set of 2) Tuff Support Front Hood Lift Struts Compatible with Subaru - Recommended for Model Years Listed Below Review

Very easy to install and I did it with the hood up so it's possible although not recommended. open 2) Use a flathead screwdriver to remove the retaining clips on the stock cowl brackets. 3) Remove one side. 4) Install the replacement bracket bottom ball by carefully removing the pin and snapping the ball onto the hinge. Carefully reinsert and lock the pin; Do the same with the top ball. 5) Follow the same procedure for the second support. It's easy to do and these props are very valuable.

Great shock absorber for the price better than factory. The price is less than half the retail price. Very easy and quick to install. I've noticed reviews that say it doesn't fit this car when it should. I was hesitant to buy based on these reviews, we were all bitten by bad Chinese products. But the fact of the matter is that people don't understand that there is a simple pin that you pull to install the shock that makes it impossible to put it on the bolt without it. Unfortunately, this…

. It's fine. Others here with 2011 and later racks report that the post swap was easy. 2010 should have a slightly different design. Pulling out the old post was difficult. There was no clip to delete (like in the new post). The ball end was pressed tightly against the rack with an internal rigid spring washer. There was no easy way to get it out as it was difficult to get the lever onto the post without damaging the threads. So I cut it out very carefully, trying not to damage the ball. See…