Rev up Your Spidey Sense 🕷️ with Pilot MVL-0301 Marvel Spiderman Valve Caps! Review

This is a great new product. All you need to know is that they include an O-ring, and that's a good thing. However, if you screw it in too tight, the o-ring will get stuck in the valve stem, preventing you from inflating the tire.

Before installation if dirty. They fit well because they are regular plastic valve stem caps that slot into the base of these tiny Deadpool heads. You can somehow squeeze them tightly when putting them on. However, they look good and the coloring was consistent and clean, which is pretty good for such small items.

Two of my orders were defective. They don't thread into my valve stem. You press on them, and if you pull with some force, they immediately disengage. I will update the review when they can send me two really good caps. They will most likely fall off while driving.

I bought these for both my friend's car and mine. My only concern was whether or not they would be stolen. The only thing to watch out for is the little rubber grommet that's inside them. She must be in the back. If you accidentally screw it on without being at the back, it will get stuck in your valve. and give you a flat tire

Conclusion Front: shit. I couldn't complete my usual penalty run in the evening because of a flat tire in these unworthy caps. Whoever the CCP engineer is that created these things is clearly lacking in skill. The rubber O-ring, which is only there to prevent dust and moisture from entering the valve stem, is small in diameter. This causes the o-ring to slip into the valve core area and in some cases (like I've had) lightly presses on the valve. An O-ring is sandwiched between the inside of the