💦 Waterproof Pigtail Plastics with 2 Cores: 6 Pairs Pack of IP65 Rated Connection Cables, Plug, and Socket Adapter for LED Light Bars Review

They are quite small. I'm not sure how much current they carry without a heater. They only cut 1/8 inch so you have to cut the cable and then more.

Many female connectors have pins that have been pushed back resulting in a poor connection. I had to take the time to get the pin in the right position to make a good connection. Very bad QA to let them go. If it was just one of them I wouldn't complain but over half the orders have been like this.

Slightly smaller than I expected. I have used some waterproof connectors similar to this one and they were larger. However, they should work fine for the application I'm going to use them for. The smaller size might even come in handy if I need to thread the end through a hole. I am happy with my purchase.

I've bought them before. They work great. They have an o-ring in the threads to keep water out. NOT WATERPROOF!. Their only downside is the size of the wire. This is less than 18 ga but more than 20 ga. They are ideal when you need a waterproof connection that is not designed for high performance. It would be better if they came in a 16ga wired version, but they are what they are. I would NOT use these light bar connectors but they work fine for a single LED position light.

The connections appear to be good and the pigtail cables are of fairly good quality with two leads molded well into the round cab; e. The only problem is that the two wires that protrude from the cable are relatively short and are only stripped a few millimeters - too short to work with. And since the wires themselves are short, it is inconvenient to remove additional insulation. And since the leads are formed into a single round cable, it's difficult to separate them further so that the extra…