Header banner
Revain logoHome Page
power supply hiper hp-400sfx 400w oem logo

Power Supply Hiper HP-400SFX 400W OEM Review

1

·

Excellent

Revainrating 5 out of 5  
Rating 
5.0
Computers, 💻 Computer Components, 🧰 Computer Internal Components, 💻 Computer Components

View on AmazonView on ЯM

Media

(7)
img 1 attached to Power Supply Hiper HP-400SFX 400W OEM
img 2 attached to Power Supply Hiper HP-400SFX 400W OEM
img 3 attached to Power Supply Hiper HP-400SFX 400W OEM
img 4 attached to Power Supply Hiper HP-400SFX 400W OEM

Description of Power Supply Hiper HP-400SFX 400W OEM

Power supply HIPER HP-400SFX (400 W) Black

Reviews

Global ratings 1
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

In the case of the Metalfish T40, I assembled a quite peppy, but very quiet and not hot entry-level gaming PCyun: i5-12400+ID-Cooling IS-47/ASRock B660M-itx/ac/2x8Gb DDR4-3733 HyperX/SSD NVMe 500Gb/Gigabyte Intel ARC A380 graphics card. This feeder went perfectly into the specified assembly both in terms of the required power (as it should, with a margin of one and a half) and in terms of the silence of operation. The CPU cooler turntables and vidyahi are also quiet, and the entire miniPC is…

Pros
  • - The price / quality / power supply ratio is adequate. - Very quiet fan, even under load. - Normal length of power cables for assembly in a miniITX case. - Obviously, I was lucky / fixed, but in idle I didn’t hear any squeak of throttles, as they wrote in other reviews on various resources. Under load, too, silence, only a slight noise from the turntable. - Absence of drawdowns on all food chains. - Good connection of 24pin and 8pin connectors to the motherboard and processor, tight, but reliable and without backlash. Availability of 8(6+2)pin connector for video card. - The presence of a tie with Velcro for wires. At the end of the assembly, it is very convenient to pull off the extra tails as compactly as possible. - Carefully sealed in a film, although there is no box in the OEM delivery.
Cons
  • - Thin wires of power cables. But under load, barely warm, so tolerable. Slightly mixed up at the exit from the PSU, but not critical. - One wire of the 24pin braid was sticking out of the plastic wire retainer ring, and was noticeably squeezed between this ring and the case. Corrected in place, in a common tourniquet. - The kit does not include a power cable and mounting screws.