🔧 Enhance Your Honda CRF50F with Pro Taper Universal Handlebar in Platinum Grey Review

I love the feeling of waiting for more parts to get the bike working again. I didn't realize the rivets are only in the middle so I don't know how well it will hold up. But I'm still planning on sending it, so I'll find out.

The bars were painted in good condition but the rivets are not on the sides for the clips and the spot where the clips tighten was not wide enough had to cut in half and weld in a new tube to bring them closer together

Very good rods. I installed them on a Mototec Demon 50cc 2-stroke minibike - easy setup, much taller and wider (my knees no longer touch the handlebars when turning). Great upgrade.

Bars look amazing live. They look so good I almost don't want to put them on my bike. Just hang them on my wall where I work on my projects! They look super comfy. I like the feel of the bars. I don't have the spare change to put them on my pit bike yet because I'm waiting for other parts. Will update the review when I do!

These are for small mini bikes like the Honda Z-50 or the Chinese pit bike and the like. This is not optional, you MUST wear it! Gives you more knee room to sit on your bike. You should put them on any pit bike or mini bike for those who ride it, kids or adults. All of the standard bars that come on mini bikes are an absolute joke. So here they are, you found them.

These are very well made bars and I love the finish. Welds look great! Pay attention to the photo as they don't work well with clamps that don't clamp in the middle. It will NOT fit the SSR 110, SSR 125 or Coolster Jumper 3 (some of the bikes I have) as the clamps on those bikes are too far apart to properly fit the handlebars. You could stuff them in there, but don't do it! They are for small bikes like the z50r!

They do not fit the Honda 50. I bought riser clamps to install them. After installation I cut them off. They are 4 inches wider than the standard 50 bars. The diameter is too large for the gas mount or grips. Too bad I didn't cut them to be able to send them back. Protaper does amazing things but this seller's description is wrong. FYI, although Revain says they can be taken back, you'll need to get permission from the company, which says there's a 50% restocking fee.