🚗 Enhance Driving Safety with RaxTDM Non-Slip Performance Foot Pedal Pads for BMW X1 E39 E46 E87 E84 E90 E91 E92 Review

I thought the installation would be difficult. But waiting for a human to do it was ages so I decided to do it myself. No instructions. but once I found the right drill, it was cake! Love it!

Bought for my 6 speed BMW E46. They look and feel great, installation was as easy as any aftermarket pedal cover. The only complaint I would like is that the hardware is way too long. The bolts on the accelerator pedal cost me almost a quarter of an inch of pedal travel and need to be trimmed. The screws on other pedals are not a problem, although you can cut them off for aesthetic reasons. All in all excellent value for money.

Easy to install. Reading reviews about the complexity of the installation, I thought not. Took me 15-20 minutes. Just because those little O-rings and nuts work on bolts with limited under-dash space. Make sure you use a 9/64 metal drill bit and a good drill that goes like butter. Read the misaligned hole questions, simply drill one hole at a time, putting on the nut, washer and bolt at alternating angles. No problem with too long a screw for the accelerator to limit the WOT from what I've…

I have to be honest I bought these expecting they might be crap and I would have lost $16 because the shipping cost wasn't worth sending them back. But I'm glad I took the risk and bought them. I'm sure the ones that sell for $60-$300 a set are thicker stuff and all, but honestly I don't see why that matters. It's 100% about the looks and no one will ever look closely enough to tell the difference between these and the expensive ones. They ate very well and just what I was looking for. I also…

It was cheap and looked good! Fits well on my e92! The only problem is that the finish on the gas pedal wasn't perfect. This required a drill and a drill that could go through metal. In fact, the installation took me a long time. Holes should be pretty accurate. I deviated slightly from one of the pedals and couldn't get the 4th screw in. Washers are thin. The accelerator pedal mounting bolts need to be cut. If not, you'll never get into the WOT. If you don't care, then skip it. I used a piece…