🏭 Industrial Electrical Recessed Remodel Housing with Multiple Voltage Options Review

Bought these to replace my old plastic Nora which was discolouring. I'm so glad I bought these metallic whites. What does it matter if they match the white ceiling and don't discolor like plastic. They also sit flush to the ceiling for a nice clean look and take a second to install.

This was the second large quantity I ordered for the project. The first batch I ordered earlier this summer had a much better quality retaining spring. And the White Ring finish was smoother than the order I just received, seems like they came from a completely different factory but they are very similar to the first batch.

The spring flanges that hold these pads in place are poorly designed and are 100% stuck in the can and cannot be removed without damaging the pad. Also, the reflector isn't as high quality as the Juno fairing, causing these Torchstar fairings to have significantly more highlights. They are almost blinding and the extra glare draws your attention straight to the light source as you enter the room, while Juno lamps are very thin and create a more comfortable atmosphere. I'm returning them to buy…

They are about 3/8-1/2 inches shorter than the brand name. The result is a huge gap between the headlight and fairing. Looks awful There is also a hole for a spring brace which shouldn't be there Also it sticks out a lot as the part is much shorter than the original. I will throw her out. The whole idea of finishing is to make the light look good and they have the opposite effect. It cost me money that I could have spent on my own brand, but I haven't been able to find one in my area. They used

This rosette was ordered for the Hyperikon 4" recessed cans. They were for the second project I have done. The first required white baffles which I believe were also made by Torchstar were. the difference is with the bright steel reflectors rather than the white deflectors. I thought the construction would be the same but it really isn't. I had no problems with this finish. Just slide it in, the prongs bite into the sunken Glass and practically refuse to come out after installation.I discovered

Perfect match for my 4" Halo New Construction IC recessed light from the Big Box Store. I was skeptical but what a surprise! They fit perfectly and although they are slightly shorter than the Halo baffles, they are actually tapered to compensate for this so they still have a nice finished look so a standard LED bulb (PAR 20) fits nicely in. In fact they are actually slightly better because they are metal and have a foam ring, to seal the drywall, which the Hal9 brand doesn't have. Also, the…

They are approximately 3/8" to 1/2" shorter than brand name. This creates a huge gap between the headlight and fairing. It looks horrible. there is a hole for a spring clip, it shouldn't be there, it also sticks out a lot as the piece is much shorter than the original, it's stamped sheet metal which is strong but will rust on the outside. I will throw her out. The whole idea of finishing is to make the light look good and they have the opposite effect. It cost me money that I could have spent…

This bezel was ordered for Hyperikon 4" backboxes. They were for the second project I was making. The first ones required white screens which I believe were also from Torchstar, the difference being bright steel reflectors rather than white Baffles were.I thought the design would be identical.But it's not.I haven't had any issues with this finish.EXCEPT THE PINS.These tabs are designed to hold the pad in place,which they do. However, if you just stick them in, the pins dig into the recessed…